The group would like to thank the following for providing comment and advice during the production of this document: Surgical Materials Testing Laboratory (SMTL), NHS Wales Health & Social Care, Northern Ireland (HSCNI) The following organisations and their representatives contributed as members of the group: We recommend that users and manufacturers submit their comments to and these will be considered when the document is next reviewed. This specification has been written to meet a demonstrated demand for transparent face masks at the time of writing (spring 2021), and it is acknowledged that further revision may be necessary. Other technical solutions may also demonstrate the safety and performance of transparent face masks. The aim of the group was to produce a technical specification, based on test methods and some of the design and performance requirements used in established/recognised standards, for transparent face masks, some of which could be considered for use as an alternative to Type IIR medical masks.Ĭompliance with this specification cannot be used as a presumption of conformity with the corresponding essential requirements of any relevant regulations which may apply to transparent face masks. Looking for the right fiberglass reinforced panels for your application? Contact Fiber-Tech today.This technical specification has been facilitated by the NHS Transparent Face Mask Working group brought together by NHS England and NHS Improvement ( NHSE/I). Optional – Gel Coat: Where additional protection against moisture penetration is desired, Fiber-Tech will add 15 mils (+-.003”) of high gloss gel coat to the interior surface of the FRP panels on special orders.Ĭontact Fiber-Tech Today for FiberCore® Fiberglass Reinforced Panels.A white pigmented polyester resin will be the final interior finish and will contain porosity on the surface. Optional – Resin Surface: For applications where sanding, laminating, or bonding to the interior surface of the FRP panel is required upon request, Fiber-Tech will eliminate the use of the clear film.This heat sealable film covers typical porosity and provides a surface which is considerably easier to clean than raw resin surfaces. Standard – Clear film: A thin clear film is laminated to the interior surface of the FRP panel during the composite panel production process.All standard Fiber-Tech gel coats are formulated to offer maximum flexibility, are acid and alkali resist and will readily accept decals and most paints. 003”) of a smooth or embossed, high gloss or matte finish designed to offer superior weathering characteristics and resistance to UV degradation. Standard panels are available in sizes up to 120” wide x 58’ long.ġ5 mils (+/. FiberCore® Fiberglass Reinforced Panel SpecificationsĪll our FRP panels are custom manufactured and cut to the customer's specified dimensions. Fiber-Tech’s ability to produce large flat fiberglass panels permit easy and rapid installation, saving considerable project time and labor dollars. You can trust a company with over 45 years of fiberglass panel manufacturing experience.Īll of Fiber-Tech's FRP panels are custom made, cut and shipped to your individual specifications, therefore minimizing waste for your special application. Fiber-Core® does not rot and is unaffected by most solvents and chemical agents, therefore extending the life of the FRP panel. Standard FiberCore® panels are available 3 mm to 5 mm thick and in sizes up to 10 feet wide by 58 feet long. We utilize thermoset polyester resins to wet-out multiple layers of woven roving fiberglass and reinforced mattes/fabrics in a “heat accelerated vacuum assisted infusion” process producing one of the industry’s largest rigid seamless FRP panels.Īll of Fiber-Tech's FRP panels are custom manufactured and cut to the customers' specified dimensions. A combination of woven roving, chopped strand mattes, core mattes and veils are molded on large lamination tables and cured under heat and pressure. FiberCore® Fiberglass Reinforced PanelsĪll FiberCore® fiberglass composite panels are manufactured by Fiber-Tech’s proven proprietary process.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |